Tag: two stroke

Some progress on the project: The original wires were a total mess, so I have to construct a new one. And since the car is now going to have a 1966 engine, the original wiring is not correct. I will use the original 1964 wiring in the cabin but the engine bay wiring is going… Continue reading Part 51. Some proggress

I have done some work on the wires. The wire harness is from the ’66 longnose since the original one was pretty much useless. I labeled almost every wire as I removed it from the car. It’s infinitely easier to put it back to a car when you know which wire is which just by… Continue reading Part 50. Electrical & Steering

2008-9-6. Suspension. I have not have too much time to spend on the project lately, but we managed put the suspension more or less together. We started with the rear end. Pretty easy stuff, except I had mislocated the plastic shims that go with the central rubber mount. But we finally found similar parts to… Continue reading Part 49. Suspension

I painted the body today. The color is from the Saab 9-5 (2007) chart and it’s called “Polar White” (it has a somewhat creamy tint to it, not pure white). Well, the coating is not perfect but all in all quite good. I didn’t leave any dry spots but I did get a few runs.… Continue reading Part 48. Paint!

We sanded the filler today (the whole car, took about 5 hours with two men working…) But the car is now ready for overcoat! Some photos: I said earlier that the area below the window frame was somewhat pitted – here’s a photo to illustrate. I had to sand a lot of the filler away… Continue reading Part 47. Sanding the filler

Filler time! It’s starting to look like the body will get it’s color this summer! I’ve sprayed the filler yesterday and today. I put on about six coats on the roof (to have plenty of the stuff to work with) and three on the sides depending on how uneven the surface looked. And two coats… Continue reading Part 46. Filler paint

Some brogress on the project: The left hand side rear fender coming along nicely. A “new” right hand side fender (Many thanks Eirik!) Only a little rust repair needed, otherwise a very good piece. For the past week I’ve been working on the roof: The rear part is pretty ok. But there’s quite a lot… Continue reading Part 45. Prepare for paint still continued

The side panels are starting to look ok: I realised that we really need to do the final fitting of the doors and fenders before I spray the overcoat on the car. It will take some time, so I’m not all that confident that I will have time to spray the car this summer. We’ll… Continue reading Part 44. Prepare for paint continued